ADH42 Stepper Motor Controller, Spontaneous pulse driver

Spontaneous pulse driver
$58.00
Qty:
(This product has a limit set to 10000 item(s) per order)

Pulse & direction stepper motor driver, support to Spontaneous pulses.
Spontaneous pulses Stepper Motor Driver

ADH42

minimum value

Typical  value 

Maximum value

Unit  

Supply Voltage (DC)

12

24

40

VDC

Control Signal
input current

7

10

16

mA

Step pulse frequency

0

-

200

KHz

insulation resistance

50

 

 


● Miniature size 42mmx42mm x21.5mm

● Pulse & direction stepper driver also support the standard RS232 serial command, and built-in 32bit digital chip.

● Using new control algorithms such for vibration suppression and low heat generation

● DC input voltage 12~40VDC, recommended working voltage 24VDC.

● Continuous output current 1.4A max, max peak current 2.1A.

● Integrated design, mounted with 42/39mm stepper motor.

● Low vibration, low noise, stable operation, low motor heating.

● Any micro-step can be set .

● Protection functions such as overvoltage, undervoltage and overcurrent.

● Built-in automatic matching function of motor parameter.

● ADM42H stepper driver can be assembled for NEMA17 Integrated Stepper Motors



Pin No.  Name  Description
1PUPulse Control Signal Input:  5V ~ 24V, Rising Edge effective, 
Make sure pulse signal effective, pulse width ≥ 2μs
Add the resistance for power supply.
2PU-
3DRDirection Signal: high/low level signal: 5V ~ 24V, direction signal should be at least 5 μs earlier than pulse signal,  High/Low level.
4DR-
5EN  Enable Signal:enable/disable.
  If ENA  connect 5V & ENA- connect low level(or Internal optocoupler on), 
stepper controller will turn off the current, motor in free state, no feedback 
even send pulses.  
6EN-
7AMAlarm signal output: When overvoltage, undervoltage, phase loss, or position deviation alarms occur, the alarm signal output is effective;
Maximum driving current 50mA
8AM-
9GNDSupply Voltage Ground: GND/0V
10DC Supply voltage:  12-40VDC, Recommend DC24V

Wire support common anode connection and common cathode connection, controlled by PLC or Pulse Generators.





DIP Switch SW1 SW2 SW3 SW4 SW5 SW6 ↑

1. Set working current by SW1:

SW1

Peak(A)

RMS(A)

off

1.4

1.0

on

2.1

1.5


2. Set Working Mode by SW2:

SW2

Working Mode

off

Pulse & Direction

on

Spontaneous pulses


 2.1.  Pulse & Direction working mode:
        Set Micro-step by SW3,SW4,SW5 SW6:



 2.1.  Spontaneous pulses working mode:
         In this working mode, the PU PU- connect to the power supply 5~24VDC
and GND,
         make sure the stepper motors rotates instantly when power on, please check below wiring diagram:

         Set Working Speed by SW3,SW4,SW5 SW6:


More Information on detail, please feel free to contact me  

Write Review

Note: Do not use HTML in the text.